Guide For Troubleshooting Your Home Heating Systems

Your furnace is a complex appliance with many components and it is susceptible to failure, like any other machine. The ability to troubleshoot your system before it fails is necessary. You may be able to handle certain issues on your own, but when in doubt, it is best to seek the assistance of a professional for heating service like Climate & Energy Solutions, serving in Chico, CA.

The following is a list of helpful tips for locating the issue with your HVAC system.

Troubleshooting Tips For Your Heating System

  • Blocked Vents

Having blocked vents throughout your home lowers the amount of heat that may reach your living spaces. Even if your heating system produces enough heat, blocked vents may prevent it from reaching your living rooms.

Conduct a comprehensive assessment of all vents and return air grilles throughout your property. Remove any furniture, rugs, carpets, or other objects sitting on or in front of the vent or grille.

  • Check The Circuit Breaker

Check the circuit breaker. Blowouts and power surges are two instances in which the breaker would trip. If your electrical system is older than your heating system, it is likely that it cannot power your new heating system. There is also the potential that the heating system’s capacitor or igniter is consuming an excessive quantity of power.

If you reset the circuit breaker and it trips again after one or two heating cycles, this requires the assistance of a professional. If there is no problem with the circuit breaker, it is time to move on to examine the heating system’s components. Contact Climate & Energy Solutions for the best heating repair in Chico, CA and the surrounding areas.

  • Ensure The Heat Setting On Your Thermostat

Adjusting the thermostat to a setting that will activate the heating system is necessary. Wait one minute after adjusting the temperature to the desired level before turning on the fan or the heater. If it doesn’t turn on, set the thermostat to 194 degrees Fahrenheit so it won’t continually turn on and off while you study the problem.

If your thermostat appears to malfunction, you should trace the wires back to the furnace and check for breakage. If you find a broken wire, you should join it together and cover it with electrical tape. A possible replacement of the battery may also be necessary.

  • Examine Your Air Registers

Perform a quick home tour and inspect each air register. Inadequate airflow or blocked air returns are likely to blame for the occurrence of hot and cold spots around your home. Verify that air can flow freely through the register by removing any obstructions, such as furniture, window coverings, or debris. Individually inspect each air register to ensure that it is fully open.

If dirt and dust are visible around the air register, remove them from the floor, wall, or ceiling and clean them well. The air circulation and air quality in your home will increase due to this modification.

Conclusion

A qualified professional’s maintenance of your home’s heating system can alleviate the wear and tear your system endures during the winter, allowing you to avoid the need for unanticipated repairs.

Contact Climate & Energy Solutions if you notice that your furnace is malfunctioning. Our certified technicians offer heating services in Chico, CA, and can conduct thorough, detailed testing and troubleshooting to discover the root cause of the problem and offer the right repairs.